Replacement Olympus Nitrate Spare Needle (red thread)

45.00

New, improved, enhanced Olympus nitrate retention cartridge

(Double the amount of resin for greater nitrate retention)

Description

Description

Reverse Osmosis (R.O) water filter Olympus lens+ for Nitrate Retention suitable for Olympus device+. Reverse Osmosis (R.O) water filter

 

Instructions for Renewal of Resin in Salt and Nitrate Algae

The salt-retention bottle (blue base cap for the small Olympus and yellow base cap for the Gigas) and the nitrate-retention bottle (red base cap for the small Olympus and white base cap for the Gigas) require regeneration of the resin as follows:

NORMAL OLYMPUS FILTER (medium):
For water with a hardness of up to 20-22 Germanic degrees the regeneration of resins should be done per 350 litres of water.

Reverse Osmosis (R.O) water filter

FILM OLYMPUSGIGA (GIAS):

The same applies as for the normal (medium) water filter. The regeneration of resins should be done in about 350 litres of water at a hardness of up to 20-22 German degrees. .

FOR THE NITRATE CARTRIDGE:

For nitrates up to 60 degrees, the regeneration of the resin should be done in about 150 litres of water. For nitrates above 60 degrees, the regeneration process should be carried out in less litres of water. The more often the process is repeated the better the nitrate reduction result will be in both our models (normal & Yiga) .

In order to regenerate the resin of each cartridge so that it can again retain salts or nitrates, the following procedure should be followed:

In order to regenerate the resin of each cartridge so that it can again retain salts or nitrates, the following procedure should be followed:

1) Unscrew the nozzle from the device
2) Fill a 1-2 litre container with water and add 3 heaping tablespoons of table salt, which you stir well to dissolve before putting the flask in.
3) Dip the resin gasket into the water, making sure it is 100% covered by the salt water.
4) After about 30-45 minutes, remove the germ from the brine and after rinsing it externally with tap water, place it back in the device.
5) Turn on the tap for about 1 minute to rinse the inside of the flask from the brine and that's it.

RESIN CARTRIDGE CHANGE

The duration of the resin cartridge is 10-12 months (like the activated carbon ceramic cartridge), so it is essential to change it.

CENTER PLUS SA
● ACHARNES: L. Karamanlis 87 (13679) Tel. 210.2405900 Fax.210.2405583
● ATHENS : 40 Veranzerou (10432) Tel. 210.5230440 Fax.210.5233388

Additional information

Additional information

Weight0.2 kg